How do you put a hydraulic throwout ball bearing in place? 

Here are some procedures to follow to ensure proper installation. 

Hydraulic release bearings must be installed. 

Measure the distance between the shaft and the bearing, then connect the fittings at the proper angles. 

When performing a bleed, the fluid should be forced through the bearing, with as few air bubbles as possible.

Installing a Hydraulic Throwout Bearing

Installing a hydraulic throwout bearing in your clutch is an excellent way to save valuable engine compartment space. 

Furthermore, these bearings make the clutch release process easier. 

They are not, however, a direct replacement of Hydraulic Clutch Release Bearing Kit. 

Certain steps must be taken in order to install this type of bearing. 

Read and re-read the installation instructions if necessary. 

A tutorial is also beneficial. 

Here are some pointers for installing the hydraulic throwout bearing.

A release bearing, lines, a bleeder fitting, and an o-ring with 0-rings on the ID are included with the hydraulic throwout bearing assembly & Hydraulic Clutch Release Bearing Kit. 

The engine must be mated to the transmission shaft before the bearing can be installed. 

Following that, lubricate the o-ring with brake fluid. 

I installed this system on a speed transmission and an engine. 

As a result, the clutch was very smooth.

Measurement to ensure proper gap

When installing a hydraulic throwout bearing, it is critical to perform the proper gap measurement. 

Make sure there is a space between the bearing and the bellhousing mounting flange. 

Place the bearing on the guide collar to accomplish this. 

The bleed line should be connected to the top fitting. 

The bleed line forces fluid into the bearing, reducing the chance of air bubbles.

When installing a clutch, the gap must be properly measured. 

The majority of clutches specify a gap of 1/16″ to 1/8″. 

Incorrect gap measurement can lead to clutch and Hydraulic Clutch Release Bearing Kit failure. 

It can cause the clutch to slip repeatedly, causing excessive wear on the clutch fingers. 

As a result, accurate gap measurement is critical. 

You will be able to correctly install a clutch if you follow this guide.