Continue reading for more information on how to adjust a hydraulic throwout bearing. 

Some people may find this simple task difficult because they do not know what to look for. 

The “Bearing” dimension should be measured to ensure that the hydraulic throwout bearing kit is functioning properly. 

You can determine the type of hydraulic throwout bearing kit assembly you require once you know the “Bearing” dimension. 

Make sure to use the proper bleed line.

If you are unfamiliar with hydraulics, watch a video tutorial on the subject and follow the instructions. 

Understanding the relationship between the clutch diaphragm and the release bearing is critical. 

The hydraulic throwout bearing kit  should be able to ride without being pressed, but it should also be precisely positioned. 

If the release bearing is not properly adjusted, the clutch will always disengage or will not engage.

The new hydraulic release bearing must be installed first. 

Make a small air gap between the bell and the clutch finger. 

The distance between the two should be approximately four millimeters (3/64) “) smaller than the size of your finger. 

Remember that if the bearing is new, there should be an air gap between the two. 

When the bearing fluid enters the system, this gap will close. 

The distance between the bell and the clutch fingers should be at least 4mm (3/16″) “, whereas a gap that is too large or too small may cause the bearing to fail and result in fluid leakage.

After installing the hydraulic release bearing, you must mate the engine and transmission as tightly as possible. 

To make it tighter, you may need to use lubricant. 

Also, ensure that the lines are properly seated so that you can easily install it. 

The lines should then be connected to the transmission. hydraulic throwout bearing kit .